| Step | | Procedure & Parts & Tools |
| 1 |
|
REMOVE THE 6 SCREWS HOLDING THE BRUSH MOTOR COVER TO MACHINE.
| Screwdriver-phillips |
|
|
| 2 |
|
PULL BRUSH MOTOR COVER FROM MACHINE.
|
| 3 |
|
FOLD THE HANDLE DOWN OVER MOTOR AND FLIP MACHINE SO BRUSH SHROUD IS FACING UP.
|
| 4 |
|
REMOVE THE 9 BOLTS HOLDING THE WEIGHT.
| Screwdriver-phillips |
|
|
| 5 |
|
REMOVE THE 3 SCREWS HOLDING THE BRUSH SHROUD.
| Screwdriver-phillips |
|
|
| 6 |
|
REMOVE THE 3 SCREWS HOLDING THE FLANGE COUPLING.
| Screwdriver-phillips |
|
|
| 7 |
|
PULL THE FLANGE COUPLING FROM THE MACHINE.
|
| 8 |
|
USE RECOMMENDED TOOL (LISTED) TO REMOVE THE SPRING. INSERT TOOL AS SHOWN, MOVE HANDLE DOWN UNTIL THE SPRING BRACKET RELEASES.
|
| 9 |
|
REMOVE THE SPRING BRACKET.
|
| 10 |
|
PULL THE BELT FROM THE MACHINE.
|
| 11 |
|
LOCATE THE BELT TENSIONER ROLLER AND BEARING.
|
| 12 |
|
LOOSEN THE BOLT HOLDING THE BELT TENSIONER ROLLER AND BEARING.
| Wrench-Allen metric 6.0mm |
|
|
| 13 |
|
PULL TO REMOVE THE BOLT AND ROLLER/BEARING FROM THE MACHINE.
|
| 14 |
|
SLIDE THE PULLEY COVER FROM THE MACHINE.
|
| 15 |
|
PULL THE SPINDLE OUT FROM MACHINE. NOTE: WHEN REPLACING SPINDLE, GREASE THE SPINDLE SEAL LIP (SHOWN BY ARROW)
|
| 16 |
|
REMOVE THE SNAP RING
| Snap ring pliers |
|
|
| 17 |
|
PULL THE PULLEY AND BEARING FROM MACHINE.
|
| 18 |
|
LOOSEN THE PIVOT BRACKET BOLT.
| Wrench-Allen metric 6.0mm |
|
|
| 19 |
|
PULL TO REMOVE THE PIVOT BRACKET AND BOLT.
|
| 20 |
|
REMOVE 2 SCREWS FROM BRUSH MOTOR BRACKET.
| Torx T30 |
|
|
| 21 |
|
REMOVE 3 SCREWS FROM SPINDLE BASE.
| Wrench-Allen metric 6.0mm |
|
|
| 22 |
|
PULL SPINDLE AND BASE FROM THE MACHINE.
|
| 23 |
|
FLIP THE MACHINE UPRIGHT AND REMOVE THE 3 SCREWS FROM THE BRUSH MOTOR BASE.
| Screwdriver-phillips |
|
|
| 24 |
|
LIFT THE MACHINE FROM THE BRUSH MOTOR.
|
| 25 |
|
REVERSE STEPS 1 THRU 24 TO INSTALL A NEW BRUSH MOTOR.
|